Notifications
Clear all
General Discussions
1
Posts
1
Users
0
Reactions
10
Views
0
01/03/2025 1:48 am
Topic starter
Installation Instructions
www.trucktok.com
EGR Delete Intake elbow pipe
2007-2010 6.6L Chevy Duramax LMM
- www.trucktok.com
- Facebook: Trucktok
- Email: service@trucktok.com
Package Includes:
- 1 * “U”Shaped Black Coolant Tube
- 1 * Exhaust Block Off Plate
- 2 * Hose Clamps 1 * O-ring
- 1 * High Flow Intake Elbow
- 1 * M8×20 Hex Head Bolts
- 2 * M8 x 25 Cap Head Bolts
- 3 * M10 x 20 Hex Head Bolts
- 2 * M8×20 Cap Head Bolts
- 1 * M8 Flange Nuts
！Before installation, confirm that：
Thishigh-performancecomponentdoesnotcomplywiththelawsandregulationsforhighway drivingandcannotbeusedonanyvehiclethathasbeenregisteredorcertifiedforuseon highways.Thismeansthatthecomponentmayonlybesuitableforracingcarsorotheroff-road vehicles.Ifitisinstalledonvehiclesdrivingonthehighway,legalissueswillbeborneby oneself.
Installation Instructions
Step 1:
- Disconnect batteries.
- Remove the passenger side inner wheel cover to drain the engine coolant, and disconnect the lower radiator pipe by removing the metal clip.
(Note: It is not necessary to completely pull out the pipe, just allow the coolant to flow out.) - Loosen the hose clamps on the intake, and disconnect the MAF sensor connector.
Installation Instructions
Step 1:
- Disconnect batteries.
- Remove the passenger side inner wheel cover to drain the engine coolant, and disconnect the lower radiator pipe by removing the metal clip.
(Note: It is not necessary to completely pull out the pipe, just allow the coolant to flow out.) - Loosen the hose clamps on the intake, and disconnect the MAF sensor connector.
Installation Instructions
Step 1:
- Disconnect batteries.
- Remove the passenger side inner wheel cover to drain the engine coolant, and disconnect the lower radiator pipe by removing the metal clip.
(Note: It is not necessary to completely pull out the pipe, just allow the coolant to flow out.) - Loosen the hose clamps on the intake, and disconnect the MAF sensor connector.
Installation Instructions
Step 1:
- Disconnect batteries.
- Remove the passenger side inner wheel cover to drain the engine coolant, and disconnect the lower radiator pipe by removing the metal clip.
(Note: It is not necessary to completely pull out the pipe, just allow the coolant to flow out.) - Loosen the hose clamps on the intake, and disconnect the MAF sensor connector.
This topic was modified 2 weeks ago 3 times by luffy@malongfei.com
